دسته بندی:
عمران - خاک و پی - Civil Engineering - Soil and Pew
سال انتشار:
2010
ترجمه فارسی عنوان مقاله:
مقایسه ظرفیت باربری یک پی نواری بر روی ماسه مسلح شده با ژئوسل و ژئوتکستایل
عنوان انگلیسی مقاله:
Comparison of bearing capacity of a strip footing on sand with geocell and with planar forms of geotextile reinforcement
منبع:
Geotextiles and Geomembranes 28 (2010) 72–84: doi:10:1016/j:geotexmem:2009:09:003
نویسنده:
S.N. Moghaddas Tafreshi a, A.R. Dawson
چکیده انگلیسی:
Comprehensive results from laboratory model tests on strip footings supported on the geocell and planar reinforced sand beds with the same characteristics of geotextile are presented. The various parameters studied in this testing program include the reinforcement width, the number of planar layers of geotextile and height of the geocell below the footing base. Contrary to other researches, the performance of the geocell and planar reinforcement is investigated at the range of low to medium settlement level, similar to those of interest in practice. The results show that the efficiency of reinforcement was decreased by increasing the number of the planar reinforcement layers, the height of the geocell reinforcement and the reinforcement width. For the same mass of geotextile material used in the tests at the settlement level of 4%, the maximum improvement in bearing capacity (IF) and percentage reduction in footing settlement (PRS) were obtained as 2.73 and 63% with the provision of geocell, respectively, while these values compare with 1.88 and 47% for the equivalent planar reinforcement. On the whole, the results indicate that, for the same quantity of geotextile material, the geocell reinforcement system behaves much stiffer and carries greater loading and settles less than does the equivalent planar reinforcement system. Therefore, a specified improvement in bearing pressure and footing settlement can be achieved using a lesser quantity of geocell material compared to planar geotextile.
چکیده فارسی:
نتایج جامع آزمایشهای مدل آزمایشگاهی بر روی پیهای نواری که بر روی بستر ماسهای مسلح شده با ژئوسل و ژئوتکستایل با خصوصیات مشابه ژئوتکستایل مصرفی مورد حمایت قرار میگیرند، ارائه شده است. پارامترهای مختلف مورد بررسی در این برنامه آزمایشی شامل طول مسلحکننده، تعداد لایههای ژئوتکستایل و ارتفاع ژئوسل در زیر بستر پی میباشد. بر خلاف سایر تحقیقات، عملکرد مسلح کننده های ژئوسل و ژئوتکستایل در دامنه سطح نشست پایین تا متوسط، مشابه با موارد اجرایی مورد بررسی قرار گرفت. نتایج نشان میدهد که با افزایش تعداد لایههای مسلح کننده ژئوتکستایل، ارتفاع مسلح کننده ژئوسل و طول مسلح کننده، کارآیی مسلح کننده کاهش مییابد. برای جرم یکسان مصالح ژئوتکستایل مورد استفاده در آزمایشها در سطح نشست ۴ درصد، با تهیه ژئوسل حداکثر بهبود در ظرفیت باربری (IF) و درصد کاهش در نشست پی (PRS) به ترتیب برابر با ۲.۷۳ و ۶۳ درصد به دست آمد، در حالی که این مقادیر برای مسلح کننده ژئوتکستایل معادل ۱.۸۸ و ۴۷ درصد به دست آمدند. در کل، نتایج نشان میدهد که برای مقدار یکسان مصالح ژئوتکستایل مصرفی، سیستم مسلح کننده ژئوسل بسیار سخت تر رفتار می-کند و بار بیشتری تحمل می کند و کمتر از سیستم مسلح کننده صفحهای معادل نشست میکند. بنابراین، بهبود مشخص شده در فشار باربری و نشست پی میتواند با استفاده از مقادیر کمتر مصالح ژئوسل در مقایسه با ژئوتکستایل به دست آید.
حجم فایل: 2680 کیلوبایت
قیمت: 50000 تومان
توضیحات اضافی: نظر
تعداد نظرات : 0